Production Studio Set-UP

Turn on the power strips on each of the three camera tripods.

This will turn on the cameras and the cameras will all move/turn to reset.

Once the cameras finish moving/resetting, go into the control room and complete the camera set-up

• Adjust the hoods so that they are not in the way of the camera lens

Turn on both of the anchor lav mics.

Make sure Anchor A (camera left) has the mic marked "CHANNEL 3"

Make sure Anchor B (camera right) has the mic marked "CHANNEL 4"

Turn on the AIDA Joystick Controller (the switch is on the back side)

While you wait for it to connect (takes a few minutes), adjust the camera hoods in the studio.

Adjust the cameras using the joystick to be the correct camera framing as noted 

• CAM 1 ("Camera 5" on the display) should be zoomed in on anchor B (the anchor on the right)

• CAM 2 ("Camera 6" on the display) should be zoomed out so both anchors are visible

• CAM 3 ("Camera 7" on the display) should be zoomed in on anchor A (the anchor on the left)